Author Topic: Float height settings (Read 1047 times)

cb750rat · « **on:** January 12, 2012, 03:08:30 PM »

Just wondering if anyone knows the correct float height settings for a '77 750f? I'm running the pd41a's. Any help would be much appreciated.

Johnie · « **Reply #1 on:** January 12, 2012, 04:14:38 PM »

This should help you out:
http://www.hondachopper.com/garage/carb_specs/carb_specs.html

72500john · « **Reply #2 on:** January 12, 2012, 05:34:52 PM »

chunked out a float gauge out of aliminum for my bike. just a suggestion.

bollingball · « **Reply #3 on:** January 12, 2012, 09:36:23 PM »

The PDs on your bike are easy to set up I don't measure the float level on these. I set them up on the bench using the clear tube method. I set them 2mm below bowl gasket never have I had a fuel feed problem low or high.
First pic with clear tube
second is where I tilt if I have to remove bowls and make adj.

Ken

70CB750 · « **Reply #4 on:** January 13, 2012, 04:23:32 AM »

I cut the gauge out of Kydex, since I had some on hand. Anything will do.

cb750rat · « **Reply #5 on:** January 17, 2012, 04:08:23 PM »

Thanks for all the info guys!

eldar · « **Reply #6 on:** January 17, 2012, 04:50:26 PM »

Set it for 14-15mm. Books says 14.5+-.5 so 14-15.
I measure from the side of the carb where the seal would press.

SOHC/4 Owners Club Forums

News:

Author Topic: Float height settings (Read 1047 times)

cb750rat

Float height settings

Johnie

Re: Float height settings

72500john

Re: Float height settings

bollingball

Re: Float height settings

70CB750

Re: Float height settings

cb750rat

Re: Float height settings

eldar

Re: Float height settings