Author Topic: oil control valves in 400F engine  (Read 1234 times)

0 Members and 1 Guest are viewing this topic.

Offline JohnS

  • Full Member
  • *
  • Posts: 11
oil control valves in 400F engine
« on: February 18, 2012, 02:13:37 PM »
Hello All,
Can I ask for some advice?
I am currently rebuilding my 400f engine.
I have just replaced the cylinder block.
The Honda parts list shows two parts  (12901-333-000 valve pile control) which I do not seem to have.
Certainly I did not take them out when I stripped the engine.
Can anyone offer me some advice?
These parts are described as obsolete by the usual suppliers.
Are they essential?
Thanks,
John

Offline Ernest T

  • Hot Shot
  • ***
  • Posts: 302
Re: oil control valves in 400F engine
« Reply #1 on: February 18, 2012, 02:53:33 PM »
I don't think you want to run without them as they seem to provide oil pressure to the valve train.  I may have a couple spares if you are sure you don't have them.

Offline JohnS

  • Full Member
  • *
  • Posts: 11
Re: oil control valves in 400F engine
« Reply #2 on: February 18, 2012, 03:11:31 PM »
Thanks Ernest.
If you have some and would be prepared to send them to me I would be very grateful.
I live in the UK.
My address is
John Shaw
The New House
Cox Lane
Stanton St John
Oxfordshire
OX33 1HW
UK
Could you let me know what you would like for them and what it would cost to send them to me?
John

Offline Ernest T

  • Hot Shot
  • ***
  • Posts: 302
Re: oil control valves in 400F engine
« Reply #3 on: February 18, 2012, 03:33:24 PM »
Where are you?

Offline JohnS

  • Full Member
  • *
  • Posts: 11
Re: oil control valves in 400F engine
« Reply #4 on: February 19, 2012, 01:36:42 PM »
Hi Ernest,
Just to say I have found some second hand oil control valves over here in the UK.
Thanks for the advice and offer.
Regards,
John

Offline Ernest T

  • Hot Shot
  • ***
  • Posts: 302
Re: oil control valves in 400F engine
« Reply #5 on: February 19, 2012, 04:09:34 PM »
You're welcome, odd yours didn't have any.  Was it running?