Author Topic: CB350 Four Brake Disc interchangeability?  (Read 636 times)

0 Members and 1 Guest are viewing this topic.

Offline dougan

  • Full Member
  • *
  • Posts: 54
    • Whobrew.com -- Free resources for home brewing
CB350 Four Brake Disc interchangeability?
« on: June 20, 2012, 09:42:45 AM »
My bike brakes fine, but after the brakes heat up, if you put the bike on the centerstand, lean it back, and spin the front wheel it will catch on the brake pad a bit at the same spot.  It only happens when it's at its hottest (even a minute of cooling will stop it) but I still think the disc is probably warped.  I'll probably do the pads too while I'm at it, for good measure.  I've never done a bike but I've done cars so I assume it's the same, plus I have a service manual so I think I'll be good once I find the parts.

I'm not finding a lot of options as far as new CB350 Four brake rotors go... are these interchangeable with any other sohc4 bike?

Thanks!
1972 CB350 Four

www.whobrew.com -- resources for home brewers

Offline flybox1

  • My wife thinks I'm a
  • Really Old Timer ...
  • *******
  • Posts: 14,301
Re: CB350 Four Brake Disc interchangeability?
« Reply #1 on: June 20, 2012, 09:46:35 AM »
probably the 400F discs will work.  hopefully someone else will chime in.
do the pads.
check the piston for pitting.
get a new caliper piston seal(be sure to really clean out the groove it sits in)
flush your lines well with new brake fluid.
'78 750K (F3 engine) PD42b's, Modified airbox w/K&N  filter, 40/110 jets, 1 needle shim, IMS@ 1 turn out. Kerker + Cone 18" QuietCore

Past Bikes
1974 550K0 (stock), 1973 CB350F (stock), 1983 Yamaha XS400K (POS)
77/78 cool 2 member #3
"Knowledge without mileage equals bullsh!t" - Henry Rollins

"This is my CB. There are many like it, but this one is mineā€¦"

Offline socalenduro

  • Hot Shot
  • ***
  • Posts: 611
Re: CB350 Four Brake Disc interchangeability?
« Reply #2 on: June 20, 2012, 09:54:10 AM »
I have a 350f Disc in my garage that ill be willing to sell you....
i bought a drilled one off ebay and my stock rotor is in the spare parts bin