« previous next »
Pages: [1]   Go Down

Author Topic: Jet needle groove distance  (Read 722 times)

0 Members and 1 Guest are viewing this topic.

Offline fmctm1sw

  • Old Timer
  • ******
  • Posts: 3,042
Jet needle groove distance
« on: July 07, 2012, 09:57:58 AM »
Anyone have a jet needle laying around?  Exactly how far apart are the grooves?  In other words, if I move my clip up or down one groove, how far is that?  Does 2mm sound close?
Logged
Quote from: 754
Dude is that a tire ? or an O-ring..??

Quote from: inkscars
This is not a pod thread
This is not a #$%* on my vacuum gauges thread
This is a help or GTFO thread.

1973 CB350F
1973 CB350G
1975 CB550K
1983 GL650I
1973 CB750K3 (http://forums.sohc4.net/index.php?topic=92888.0)
1984 Kawasaki KLT-250 (AKA 3 wheeler of death)
1994 Honda TRX300
1999 Honda TRX250

Offline lucky

  • Really Old Timer ...
  • *******
  • Posts: 6,715
Re: Jet needle groove distance
« Reply #1 on: July 07, 2012, 10:11:27 AM »
2mm=.078 thousandths. That is MORE than 1/16 inch.
That is way too much.

The space between the grooves is .020 thousandths.
The clip is .012 thickness.
Logged

Offline fmctm1sw

  • Old Timer
  • ******
  • Posts: 3,042
Re: Jet needle groove distance
« Reply #2 on: July 07, 2012, 03:29:39 PM »
Thanks    :)
Logged
Quote from: 754
Dude is that a tire ? or an O-ring..??

Quote from: inkscars
This is not a pod thread
This is not a #$%* on my vacuum gauges thread
This is a help or GTFO thread.

1973 CB350F
1973 CB350G
1975 CB550K
1983 GL650I
1973 CB750K3 (http://forums.sohc4.net/index.php?topic=92888.0)
1984 Kawasaki KLT-250 (AKA 3 wheeler of death)
1994 Honda TRX300
1999 Honda TRX250

Offline lucky

  • Really Old Timer ...
  • *******
  • Posts: 6,715
Re: Jet needle groove distance
« Reply #3 on: July 07, 2012, 05:31:58 PM »
Quote from: fmctm1sw on July 07, 2012, 03:29:39 PM
Thanks    :)

You are welcome.
It was easy as I had a set of carb needles sitting right here on my work table.
Logged
Pages: [1]   Go Up
« previous next »