« previous next »
Pages: [1]   Go Down

Author Topic: PAMCO Ignition  (Read 1150 times)

0 Members and 1 Guest are viewing this topic.

Offline 72_350_FOUR

  • Enthusiast
  • **
  • Posts: 127
PAMCO Ignition
« on: July 22, 2012, 05:59:52 AM »
Hi Guys, i just bought a PAMCO, does anyone know where i get the coils also for my 350f ? I don't see it on that website.
Logged
1972 Honda CB350F

Offline 72_350_FOUR

  • Enthusiast
  • **
  • Posts: 127
Re: PAMCO Ignition
« Reply #1 on: July 22, 2012, 05:01:19 PM »
anybody ??
Logged
1972 Honda CB350F

72500john

  • Guest
Re: PAMCO Ignition
« Reply #2 on: July 22, 2012, 05:13:57 PM »
dyna makes coils that will fit on our bikes. just make sure the ohm value of the primary coil you install is the same as the one you take off. i think it will be 5 ohms. they will use automotive type plug wires to hook into the coils. i bought a set of accell 7 mm wires for a v8 at the local auto parts store and cut them to length. have 4 spares. replace the plug caps while you are at it. they are cheap.
Logged

Offline BobbyR

  • Really Old Timer ...
  • *******
  • Posts: 12,367
  • Proud Owner of the Babe Thread & Dirty Old Man
Re: PAMCO Ignition
« Reply #3 on: July 22, 2012, 07:44:02 PM »
Check with CB750 supply. I bought some coils from them.
Logged
Dedicated to Sgt. Howard Bruckner 1950 - 1969. KIA LONG KHANH.

But we were boys, and boys will be boys, and so they will. To us, everything was dangerous, but what of that? Had we not been made to live forever?

Offline 72_350_FOUR

  • Enthusiast
  • **
  • Posts: 127
Re: PAMCO Ignition
« Reply #4 on: July 23, 2012, 05:28:37 AM »
72500 - your saying to replace the plug caps on the Accel set ?  thanks for the replies guys.
Logged
1972 Honda CB350F

72500john

  • Guest
Re: PAMCO Ignition
« Reply #5 on: July 23, 2012, 06:00:44 PM »
i got a set of accel wires from the local auto parts store for a v8 auto engine, they had copper conductors. the coils i got from dyna ( p/n dc8-1) utilize the same method to connect the wires to the coil as a car distributor cap. bought 4 new ngk caps. crimped the wire connectors on to the ends to hook up to the coils. cut the wires to length and screwed on the new ngk caps. best part is i have 4 extra wires and the whole set was around 27 bucks. below are pics.



Logged

72500john

  • Guest
Re: PAMCO Ignition
« Reply #6 on: July 23, 2012, 06:06:50 PM »
sorry forget, yes. replace the caps on the acccel set. like i said the set i got was for automotive use so i just cut them off. the ngk ones have resistors built in. i think its 5000 ohms.
Logged
Pages: [1]   Go Up
« previous next »