« previous next »
Pages: [1]   Go Down

Author Topic: fork filler cap  (Read 1089 times)

0 Members and 1 Guest are viewing this topic.

Offline wardenerd

  • Expert
  • ****
  • Posts: 816
  • '77 550F '81 650C
fork filler cap
« on: October 13, 2012, 07:25:49 PM »
Are the fork filler caps on my 1977 550F under pressure I want to pull them for polishing.
Logged

Offline goldarrow

  • one day, i'll be an
  • Old Timer
  • ******
  • Posts: 3,361
Re: fork filler cap
« Reply #1 on: October 13, 2012, 07:35:00 PM »
Quote from: wardenerd on October 13, 2012, 07:25:49 PM
Are the fork filler caps on my 1977 550F under pressure I want to pull them for polishing.

Fork spring is in the fork, so spring load is there.  But you should be able to just loosen it using wrench, then turn it using hand, push it down as you turn it. Go slow and be careful as it will fly off and might hit your face.
Logged
Life Is Full Of Challenges - And My Backyard Is Full Of SOHC4's

CB550 K0
CB750 K0, K2, K23 JDM, K45, K5
And the little ones z50r, xr50r, st90


750k5 http://forums.sohc4.net/index.php?topic=114817.0

Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: fork filler cap
« Reply #2 on: October 13, 2012, 07:52:11 PM »
Jack up or otherwise support the front end to take the pressure off the springs.  It won't make a big difference for removing the caps, but will make installing them much easier.  If you don't support the front, only remove one cap at a time or your bike will fall on its face.
Logged
Pages: [1]   Go Up
« previous next »