im having trouble identifying my headers to figure out which one goes in which port. I was not the one who disassembled it so i have no reference. there are two bent pipes with angled cuts at the ends and then two straight pipes. The angled ones are both the same direction. Is this right? I figured the pipes could have been swapped at some point and mismatched but they were snug on the bike before they were taken off. My question is do the angled pipes go on the inside or outside? I think I may have it worked out with the angled pipes on the outer two ports but id like an expert opinion if anyone has one to offer. Thank you. Its a cb350f btw and I dont have a picture at the moment. Thx again.
