« previous next »
Pages: [1]   Go Down

Author Topic: Handlebar grip size  (Read 1220 times)

0 Members and 1 Guest are viewing this topic.

Offline gregripko

  • Hot Shot
  • ***
  • Posts: 689
Handlebar grip size
« on: February 14, 2013, 07:57:37 PM »
Cb550K

Just wondering.... Would 4 1/2 inch length handlebar grips work? Or do they have to be a certain length as well....
Logged

Offline bjbuchanan

  • Master
  • *****
  • Posts: 2,276
Re: Handlebar grip size
« Reply #1 on: February 14, 2013, 08:24:31 PM »
4.5" will probably work. If they are too long just trim your throttle tube, it is only nylon anyway.

Most grips are similar sized in length so it will prob match right up
Logged
The dirty girl-1976 cb750k, Ebay 836, Tracy bodykit
Round top carbs w/ 38 pilots, middle needle position, airscrew 7/8ths out, 122 main jet
Stock airbox w/ drop in K&N, Hooker 4-1

Don't trust me alone with a claw hammer and some pliers

Offline gregripko

  • Hot Shot
  • ***
  • Posts: 689
Re: Handlebar grip size
« Reply #2 on: February 14, 2013, 09:09:03 PM »
Was actually worried about it running short as I see a lot of grips 5 1/2 for cb550 on eBay
Logged

Offline gregripko

  • Hot Shot
  • ***
  • Posts: 689
Re: Handlebar grip size
« Reply #3 on: February 14, 2013, 10:58:27 PM »
Btw the throttle grips inner diameters I bought are slightly different....I'm a noob at this
Logged

Offline neevo

  • Enthusiast
  • **
  • Posts: 118
Re: Handlebar grip size
« Reply #4 on: February 15, 2013, 12:27:05 AM »
Quote from: gregripko on February 14, 2013, 10:58:27 PM
Btw the throttle grips inner diameters I bought are slightly different....I'm a noob at this

Yep, one slides on the throttle tube (bigger one), the other straight into the handlebar.
Logged

Offline Rigid

  • She likes a
  • Expert
  • ****
  • Posts: 821
  • Speak from personal experience, or don't
    • KingCustomCycles
Re: Handlebar grip size
« Reply #5 on: February 15, 2013, 04:04:19 AM »
The grips often come with a little foam plastic spacer to take up the gap. 
Logged
36 years of this stuff, here to help.

Offline K5 Keith

  • Full Member
  • *
  • Posts: 75
Re: Handlebar grip size
« Reply #6 on: February 15, 2013, 10:07:27 AM »
I replaced my 5" OEM grips with 4 1/2" grips and found that my hand seemed to cramp up a lot. Soon after I switched back to a new 5" set and I'm happy again. I'm also using stock Honda bars which locate the controls and didn't care for the 1/2" that the bars extended beyond the grip end. I suppose if I had liked the 4.5s I could have cut the bar shorter though...

(75 cb750 with 400F bars)
Logged
Pages: [1]   Go Up
« previous next »