Topic: Found oil leak

[uksparky]

Well i found my oil leak its coming from the cover on the oil pump..held on with three phillips screws...anyone know where i can get the thin oil seal that fits in the cover

[mronegear]

what bike are you riding?

As to say for the cb 500/550 Four, there is no such a cover-seal or o-ring to get via cmsnl.com
I guess in europe these seals are very rare...

good luck!

[uksparky]

what bike are you riding?

As to say for the cb 500/550 Four, there is no such a cover-seal or o-ring to get via cmsnl.com
I guess in europe these seals are very rare...

good luck!

Thanks for the partsinfo... cb 550 lt..looks like i am screwed..that small O ring is part of the pump..have to try parts store

[freeze]

Copied from another post... (thanks Bryanj)

"However to help all out I have been doing some research and discovered that whilst Honda do not list the cover "O" ring as a separate part for the 500/550 the correct size is used on other bikes and so for those in need here are the part numbers and sizes:-

91305-426-003 oil pump cover      46x2     one required
91302-377-000 suction and feed   15x2.5  two required
91302-250-010 casing to block     47x3      one required


Best wishes to all and hope that that helps


« Last Edit: January 19, 2013, 09:50:42 AM by bryanj » "

[Dave Voss]

It's a 46x2mm o-ring, McMaster-Carr sells them in both Buna-N rubber (like the stock o-ring) and Viton, which has a higher temperature rating.  I use the Viton part number 9263K665 that comes in a quantity of 10 for about $8, if you give me your address in a PM, I'll mail one of my extras to you.

[trueblue]

When I did my 650 I just took all the o-rings into the local bearing shop and got them matched size for size.  Cost me about $2

[dave500]

any time im at the bearing place i get a hand full of o rings we commonly use for about 8 bucks.

[mronegear]

Copied from another post... (thanks Bryanj)

"However to help all out I have been doing some research and discovered that whilst Honda do not list the cover "O" ring as a separate part for the 500/550 the correct size is used on other bikes and so for those in need here are the part numbers and sizes:-

91305-426-003 oil pump cover      46x2     one required
91302-377-000 suction and feed   15x2.5  two required
91302-250-010 casing to block     47x3      one required


Best wishes to all and hope that that helps


« Last Edit: January 19, 2013, 09:50:42 AM by bryanj » "

thanx for that info, freeze!

[uksparky]

Thanks to everyone that helped me..

[dave500]

get two sets.

[Duanob]

get two sets.

Yes always buyu two sets of o-rings, they are cheap but easily destroyable.