« previous next »
Pages: [1]   Go Down

Author Topic: spark plug wires  (Read 663 times)

0 Members and 3 Guests are viewing this topic.

Offline neilc

  • Hot Shot
  • ***
  • Posts: 477
  • old school biker,other bike is a 2003 vtx1800c
spark plug wires
« on: May 06, 2013, 09:12:07 AM »
now where i can get pug wires AW-82 looks like made by TER not sure of last letter,they are not stock coils for my 1970-71 cb750k because i have a RC engineering electronic ignition,multy strand copper center,they are 7mm
« Last Edit: May 06, 2013, 02:25:11 PM by neilc »
Logged

Offline flybox1

  • My wife thinks I'm a
  • Really Old Timer ...
  • *******
  • Posts: 14,301
Re: spark plug wires
« Reply #1 on: May 06, 2013, 09:18:45 AM »
IIRC TEK are stock.
get plug wires and NGK splice kits at an auto parts store.
Logged
'78 750K (F3 engine) PD42b's, Modified airbox w/K&N  filter, 40/110 jets, 1 needle shim, IMS@ 1 turn out. Kerker + Cone 18" QuietCore

Past Bikes
1974 550K0 (stock), 1973 CB350F (stock), 1983 Yamaha XS400K (POS)
77/78 cool 2 member #3
"Knowledge without mileage equals bullsh!t" - Henry Rollins

"This is my CB. There are many like it, but this one is mine…"

Offline neilc

  • Hot Shot
  • ***
  • Posts: 477
  • old school biker,other bike is a 2003 vtx1800c
Re: spark plug wires
« Reply #2 on: May 06, 2013, 02:18:25 PM »
 i snipped my wires back today and the bike runs alittle smoother now,so i think i'll replace the wires,all i could find was accell superstock 3008,but they had a few less strands of copper on the inside?think i'll look around
Logged

Offline bjbuchanan

  • Master
  • *****
  • Posts: 2,276
Re: spark plug wires
« Reply #3 on: May 07, 2013, 04:14:16 AM »
I run the super stocks with no complaints. Just make sure you get the wire in there good when you put it into the coil
Logged
The dirty girl-1976 cb750k, Ebay 836, Tracy bodykit
Round top carbs w/ 38 pilots, middle needle position, airscrew 7/8ths out, 122 main jet
Stock airbox w/ drop in K&N, Hooker 4-1

Don't trust me alone with a claw hammer and some pliers
Pages: [1]   Go Up
« previous next »