« previous next »
Pages: [1]   Go Down

Author Topic: Adjustable steering stops GL1000 front end conversion  (Read 744 times)

0 Members and 1 Guest are viewing this topic.

Offline azuredesign

  • Knupping pin
  • Master
  • *****
  • Posts: 1,705
Adjustable steering stops GL1000 front end conversion
« on: June 13, 2013, 08:40:43 AM »
Anyone have a photo of how they did this? Did you drill and tap the stops, or just drill the base of the tree next to the stops? If you drilled the stop, how large a diameter thread did you use?

Thanks for any help!
Logged

Offline mrrch

  • Hot Shot
  • ***
  • Posts: 652
Re: Adjustable steering stops GL1000 front end conversion
« Reply #1 on: June 13, 2013, 01:55:49 PM »

I drilled and tapped out the stops on the lower tree.
I think the size was 10-24. Cannot remember, just matched to some small allen head screws I had.
It drilled quite easily.
Logged
my build

1977 CB750K WITH 1976 CB750F ENGINE

Offline azuredesign

  • Knupping pin
  • Master
  • *****
  • Posts: 1,705
Re: Adjustable steering stops GL1000 front end conversion
« Reply #2 on: June 13, 2013, 04:28:17 PM »
Thanks, although it is difficult to see the screws in place in that photo even when I enlarge it.
Also, while I recognize the upper tree, my lower GL tree is different to yours. I will follow your lead and post a photo when I am finished.

Logged

Offline mrrch

  • Hot Shot
  • ***
  • Posts: 652
Re: Adjustable steering stops GL1000 front end conversion
« Reply #3 on: June 14, 2013, 06:57:09 AM »
It's my stock 77 750K triple tree. No screws in place in that but you can see the tapped holes.
Logged
my build

1977 CB750K WITH 1976 CB750F ENGINE
Pages: [1]   Go Up
« previous next »