Here's a list of what was done, as best I can remember:
-new front and rear wheel bearings, new bearings in the cush drive, new bearings in the steering stem
-rebuilt & painted the master cylinder and front brake, new stainless steel brake lines & pads (they now squeak)
-cleaned up the rims, new tubes and tires
-new sprockets & O-ring chain, new battery
-repainted the idiot light assembly
-new rubber grommets to go with the new side panels
-new rubber tank mounts, front and rear
-new rectifier/voltage regulator (one of the two was bad so I replaced them both with a solid state unit)
-new fuse block and headlight high/low beam relays from HondaMan, (HondaMan's transistorized ignition on the shelf to be installed)
-carbs and fuel tank petcock rebuilt,
-forks disassembled, cleaned up, new seals and oil (still kind pogos with 20W oil)
-misc. electrical
.....and a lot of cleaning.