« previous next »
Pages: [1]   Go Down

Author Topic: Pamco setup questions  (Read 482 times)

0 Members and 1 Guest are viewing this topic.

Offline gregripko

  • Hot Shot
  • ***
  • Posts: 689
Pamco setup questions
« on: November 11, 2013, 07:36:24 PM »
Pamco ignition with cb550... Have cb900 coils and d7ea spark plugs with caps that show a 5 and then symbol.... Guessing this means 5,000.... Is this a proper setup? Not too familiar with the whole resistor cap or plug setup but I just wanted to make sure I had the right setup.... Thanks p.s. Please no warnings about the cb900 coils... Been running them for over 6 months and they run great
Logged

Offline Lost and Confused

  • Bob
  • Enthusiast
  • **
  • Posts: 209
  • An old fart !!
Re: Pamco setup questions
« Reply #1 on: November 12, 2013, 05:46:02 AM »
I run the Pamco with resistor plugs and aftermarket 3 ohm coils. No caps. Bike starts right up.
I think I remember hearing that the Pamco is pretty forgiving as to what you use with it.



Bob
Logged

Offline gregripko

  • Hot Shot
  • ***
  • Posts: 689
Re: Pamco setup questions
« Reply #2 on: November 12, 2013, 10:01:11 AM »
Bike runs pretty good for me as well so I'm assuming I have the right setup... I have d7ea with 5k ohm caps..... Just hope this is the best combination to have
Logged
Pages: [1]   Go Up
« previous next »