Author Topic: Valve adjuster screws, too far gone now? (Read 446 times)

70CB750 · « **on:** February 22, 2014, 08:02:04 AM »

I took these out of the F2 engine, are they too far gone?

Regrind or polish it out?

MRieck · « **Reply #1 on:** February 22, 2014, 08:10:10 AM »

Those are done and will ruin the valve tips (if you have new valves). They are not that expensive.

70CB750 · « **Reply #2 on:** February 22, 2014, 08:29:50 AM »

Thank you, I will get a new set - likely from Dynoman unless there is other, better source.

Puntas13 · « **Reply #3 on:** February 22, 2014, 08:38:03 AM »

Whats wrong with them? So I know when to replace mine.

70CB750 · « **Reply #4 on:** February 22, 2014, 09:18:13 AM »

I believe they are supposed to be lightly domed with hardened surface.

Here is a picture from Dynoman.

TwoTired · « **Reply #5 on:** February 22, 2014, 12:41:33 PM »

Quote from: Puntas13 on February 22, 2014, 08:38:03 AM

Whats wrong with them? So I know when to replace mine.

The tips need to be smooth like they are polished and have the same surface geometry. Files and sand paper have a coarse surface to abrade what they rub against. You don't want that going on inside your engine.

SOHC/4 Owners Club Forums

News:

Author Topic: Valve adjuster screws, too far gone now? (Read 446 times)

70CB750

Valve adjuster screws, too far gone now?

MRieck

Re: Valve adjuster screws, too far gone now?

70CB750

Re: Valve adjuster screws, too far gone now?

Puntas13

Re: Valve adjuster screws, too far gone now?

70CB750

Re: Valve adjuster screws, too far gone now?

TwoTired

Re: Valve adjuster screws, too far gone now?