« previous next »
Pages: [1]   Go Down

Author Topic: Where can I get these crush washers?  (Read 1221 times)

0 Members and 1 Guest are viewing this topic.

Offline Anton

  • Enthusiast
  • **
  • Posts: 202
Where can I get these crush washers?
« on: February 28, 2014, 08:03:20 PM »
Anyone know where I can get these crush washers that go on the bottom side of the little bracket under the cylinder head side covers?

gracias
Logged

Offline Anton

  • Enthusiast
  • **
  • Posts: 202
Re: Where can I get these crush washers?
« Reply #1 on: February 28, 2014, 08:03:46 PM »
their number 16
Logged

Offline Bru-tom

  • Hot Shot
  • ***
  • Posts: 514
Re: Where can I get these crush washers?
« Reply #2 on: February 28, 2014, 08:27:59 PM »
i just replaced mine with copper washers. Got them from a industrial hose and fitting shop.
Logged

Offline Bootlegger56

  • Butch
  • Hot Shot
  • ***
  • Posts: 401
  • Nuthin' taps ya out quicker than cole corn likker!
Re: Where can I get these crush washers?
« Reply #3 on: February 28, 2014, 08:38:54 PM »
Feebay.....I think they are 10 or 11 mm copper crush washers.  You could buy them from Western Hills Honda but you need to take a pill before you look at the price.  You might even be able to find them at a local hardware.
Logged
Ya can travel near or ya can travel far; but no matter where ya go thar ya are!

750 K5
550 K1

Offline Anton

  • Enthusiast
  • **
  • Posts: 202
Re: Where can I get these crush washers?
« Reply #4 on: February 28, 2014, 08:46:16 PM »
cool, thanks guys
Logged

Offline Rgconner

  • Hot Shot
  • ***
  • Posts: 674
Re: Where can I get these crush washers?
« Reply #5 on: February 28, 2014, 09:08:32 PM »
I got mine from the local ACE Hardware, 10mm
Logged
1975 CB550K aka "Grease Monkey"

Offline Anton

  • Enthusiast
  • **
  • Posts: 202
Re: Where can I get these crush washers?
« Reply #6 on: February 28, 2014, 09:15:58 PM »
It shows as 6.5mm on the Honda fiche
Logged

Offline Dimitri13

  • Not a
  • Master
  • *****
  • Posts: 1,603
  • 1974 CB550K
Re: Where can I get these crush washers?
« Reply #7 on: February 28, 2014, 11:53:51 PM »
That's 6.5mm ID because the bolts are 6mm. The OD is important too because they need to fit within that bracket.
Logged

Offline ncstatecamp

  • Expert
  • ****
  • Posts: 799
Re: Where can I get these crush washers?
« Reply #8 on: March 01, 2014, 01:34:21 AM »
What bike is that?
Logged

Offline Anton

  • Enthusiast
  • **
  • Posts: 202
Re: Where can I get these crush washers?
« Reply #9 on: March 01, 2014, 09:19:59 AM »
cb550
Logged
Pages: [1]   Go Up
« previous next »