« previous next »
Pages: [1]   Go Down

Author Topic: velocity stack  (Read 893 times)

0 Members and 1 Guest are viewing this topic.

Offline el__burro

  • Full Member
  • *
  • Posts: 16
velocity stack
« on: May 05, 2014, 03:12:23 pm »
Hello,
I am planning to replace the air filter with 4 velocity stack.
What is the diameter I need to look for.
Bike is a cb750 k2.

Thanks
el__burro
Logged

Offline Stilltime

  • Hot Shot
  • ***
  • Posts: 353
  • Building my Dream
Re: velocity stack
« Reply #1 on: May 05, 2014, 03:26:57 pm »
Check out Steel Dragon Performance, they'll get you hooked up!
Logged
'78 CB550 - Orange Crush

Offline Stoli

  • Hot Shot
  • ***
  • Posts: 583
Re: velocity stack
« Reply #2 on: May 05, 2014, 07:12:22 pm »

I'd measure the intakes to be sure. Never know if a PO replaced the carbs at some point. They are most likely either 40mm or 44mm.
Logged
My Project Threads:
Project #1 - http://forums.sohc4.net/index.php?topic=117106.0  First bike
Project #2 - http://forums.sohc4.net/index.php?topic=127364.0  Something different
Project #3 - http://forums.sohc4.net/index.php?topic=123831.0  Long and Low

Offline dusterdude

  • Really Old Timer ...
  • *******
  • Posts: 8,469
Re: velocity stack
« Reply #3 on: May 06, 2014, 09:48:59 am »
Iirc,they are inch and a half od


Sent from my iPhone using Tapatalk
Logged
mark
1972 k1 750
1949 fl panhead
1 1/2 gl1100 goldwings
1998 cbr600 f3

Offline andrewk

  • doin' it.
  • Hot Shot
  • ***
  • Posts: 626
Re: velocity stack
« Reply #4 on: May 06, 2014, 10:19:59 am »
round tops are 40mm od, just proud of 1.5 inches.
Logged

Offline jdubb1977

  • Enthusiast
  • **
  • Posts: 175
Re: velocity stack
« Reply #5 on: May 07, 2014, 09:04:10 am »
+1 for Steel Dragon.  I sent them a picture of my carbs just to make sure, and they replied right away confirming that their stacks would fit.
Logged
Pages: [1]   Go Up
« previous next »