Author Topic: Points or Dyna S on CB650?  (Read 953 times)

0 Members and 1 Guest are viewing this topic.

Offline zeech

  • Enthusiast
  • **
  • Posts: 229
Points or Dyna S on CB650?
« on: May 26, 2014, 10:39:03 PM »
Trying to get rid of the ignitor boxes and finicky ignition and wondering if it's possible to run tried and true points or a Dyna S with a 1979 CB650? I plan on running Dyna coils as well. Thanks for any help.

Offline Rgconner

  • Hot Shot
  • ***
  • Posts: 674
Re: Points or Dyna S on CB650?
« Reply #1 on: May 27, 2014, 12:04:18 PM »
Hondaman Ignition.

1975 CB550K aka "Grease Monkey"

Offline zeech

  • Enthusiast
  • **
  • Posts: 229
Re: Points or Dyna S on CB650?
« Reply #2 on: May 27, 2014, 12:16:54 PM »
I'm not seeing how that will work in replacing the ignitors, perhaps I just don't understand it.

It looks like this guy is/was running a Dyna S right to the coils like I'm trying to do: http://forums.sohc4.net/index.php?topic=17895.0

I'll have to see if the plate for the Dyna S bolts right on to a 650. Is so, I forget which Dyna coils I need when running with the Dyna S, 3ohm or 5ohm?

Offline Rgconner

  • Hot Shot
  • ***
  • Posts: 674
Re: Points or Dyna S on CB650?
« Reply #3 on: May 27, 2014, 12:31:43 PM »
It is hybrid. Instead of carrying the entire voltage of the spark across the points, they are 12 volt switches that trigger the transistorized ignition of the HondaMan unit.

Much simpler to install, can be disabled to run on just the points in minutes on the side of the road, and is very reliable.

Uses around 5w, keeping the load down on the limited power the alternators produce.

Oh, and a damn sight cheaper too.
1975 CB550K aka "Grease Monkey"

Offline PeWe

  • Really Old Timer ...
  • *******
  • Posts: 15,581
  • Bike almost back to the 70's 2015
Re: Points or Dyna S on CB650?
« Reply #4 on: May 27, 2014, 01:00:22 PM »
I'm not seeing how that will work in replacing the ignitors, perhaps I just don't understand it.

It looks like this guy is/was running a Dyna S right to the coils like I'm trying to do: http://forums.sohc4.net/index.php?topic=17895.0

I'll have to see if the plate for the Dyna S bolts right on to a 650. Is so, I forget which Dyna coils I need when running with the Dyna S, 3ohm or 5ohm?
Other CB650 owners might chime in if they have tested Dyna S.
The charging system must be able to cope with Dyna S and 3 ohm coils. My bike (CB750) did not, battery drained rather quick with headlight on.
Changed to Dyna 5 ohm coils almost direct, max 40 minute test drive, 20 with headlight on. Engine barely started on starter when returned back, and needed to start bike again to drive into the garage. Returned the coils to my local shop for 5 ohms.
CB750 K6-76  970cc (Earlier 1005cc JMR Billet block on the shelf waiting for a comeback)
CB750 K2-75 Parts assembled to a stock K2

Updates of the CB750 K6 -1976
http://forums.sohc4.net/index.php/topic,180468.msg2092136.html#msg2092136
The billet block build thread
http://forums.sohc4.net/index.php/topic,49438.msg1863571.html#msg1863571
CB750 K2 -1975  build thread
http://forums.sohc4.net/index.php/topic,168243.msg1948381.html#msg1948381
K2 engine build thread. For a complete CB750 -75
http://forums.sohc4.net/index.php/topic,180088.msg2088008.html#msg2088008
Carb jetting, a long story Mikuni TMR32
http://forums.sohc4.net/index.php/topic,179479.msg2104967.html#msg2104967