Topic: brake fluid leaking from hard pipe nut

[evanphi]

I have finally figured out what might be my problem with mileage... the hard pipe to the caliper was bent funny to the rubber holder on the fender, and I think it was acting like a spring and holding the pad to the rotor. Derp.

Now that I have the holder bent out of the way so the top of the pipe sits freely, whenever I hold the brake lever, I see fluid seeping out around the pipe at the connection to the caliper. Not coming through the threads, but in the middle of the nut around the pipe. The nut is nice and tight.

I figure it is probably a crack in the pipe flare that is allowing the fluid to seep out. I'm not riding the bike until I get it diagnosed.

Anyone else have a similar issue/solution?

[flybox1]

If it wont torque down properly and seal, get a new one.  They are cheap and available.
If you have long brake lines, run it directly to the caliper with a splicer(two male ends)

[calj737]

Whatever is the cause, fix it! Very dangerous despite the mileage impact. And while you're at it, evaluate your pads since this constant rubbing may have worn them prematurely.

[evanphi]

They are new pads as of last year. No significant wear on them.

I am going to order a new pipe from slingshot cycles. Previous good experience in the past!