« previous next »
Pages: [1]   Go Down

Author Topic: cylinder hone cb750  (Read 657 times)

0 Members and 1 Guest are viewing this topic.

Offline la ca fe

  • Enthusiast
  • **
  • Posts: 141
cylinder hone cb750
« on: June 22, 2014, 01:44:41 AM »
What is the best size flex hone needed to clean out stock, 2 1/2" wide, engine cylinders walls.
Should I get one that is 1/2" over, 1" over?
And what grit is best to seat new rings?
Thanks a lot.
« Last Edit: June 22, 2014, 08:38:24 AM by la ca fe »
Logged
1976 cb750k
1975 cb750 f

1977 xs750
1978 xs400

Offline flybox1

  • My wife thinks I'm a
  • Really Old Timer ...
  • *******
  • Posts: 14,301
Re: cylinder hone cb750
« Reply #1 on: June 22, 2014, 06:25:32 AM »
Size is based on your bore.
Mine was 320grit.
Logged
'78 750K (F3 engine) PD42b's, Modified airbox w/K&N  filter, 40/110 jets, 1 needle shim, IMS@ 1 turn out. Kerker + Cone 18" QuietCore

Past Bikes
1974 550K0 (stock), 1973 CB350F (stock), 1983 Yamaha XS400K (POS)
77/78 cool 2 member #3
"Knowledge without mileage equals bullsh!t" - Henry Rollins

"This is my CB. There are many like it, but this one is mine…"
Pages: [1]   Go Up
« previous next »