Topic: cam stud replacement

[wierzbarecording]

Rebuilding my top end on my 72 cb750. I just started pulling up a can stud while torquing down.

What is the proper way to fix this? Should I replace them all? Just the one in question? Is it possibly because my torque wrench is out of spec?


Thanks in advance.
Kyle

[flybox1]

Pulling it out as in stripping the threads? It's only 6mm...
Needs to be done.correctly as it's open ended and is a source for leaks.....

[wierzbarecording]

Yes. Its not biting the threads anymore.

You can see its about 1 thread out in the picture.

[wierzbarecording]

So my plan right now is to get the stud out without destroying it, then helicoil the hole and reuse the stud. I was going to make sure there is plenty of thread sealer on the coil and stud.

Am I on the right track?

[Nic]

So my plan right now is to get the stud out without destroying it, then helicoil the hole and reuse the stud. I was going to make sure there is plenty of thread sealer on the coil and stud.

Am I on the right track?

exactly