Hi everyone, here is a little update of my project going on :
I've taken many parts of the bike so far and I'm alsmost at the point of getting the engine off
I've tooked the compression readings and I got 135 PSI on cylinder 1 & 4...the two other cylinder were to dificult to get good readings with the tool I have in a hand....
So probably the engine is not so bad...I hope
I do not know yet what I'll do with the engine but something is for sure I'm tearing it down in pièces to have a new painting on it...so I'll doublecheck everything while I'm there and take decision at the same time...
I've read that it is almost impossible to have slight oversized pistons for those «black engines» is that true or is there a well hidden place where I can buy some???
If I was to buy a restoration book, would you guys suggest to go with the «Clymer» one or the one published by Hayden??
I thank you in advance for your precious help