The Biltwell handlebars arrived so I am now able to start fitting the controls and finish up the wiring.
I made a new V-shaped speedometer mounting bracket out of stainless steel so I could mount the headlight switch in the same location. Took me a while to figure out the best place to mount it. I don't think it will look to conspicuous when I get it all buttoned up. I also made the C-shaped bracket that wraps around the bars out of stainless and the brass spacer that keeps it all wedged in place.
I bought a Motion Pro speedo cable for a CB 360. Its three inches shorter than a 750 cable. Looks like it's going to work great.
The controls also arrived, but I'm sending the master cylinder back. The package was opened and it looks like it was installed at some point and knocked around a bit. It has a few scuffs and scrapes. It's supposed to be new. The clutch control is fine.
I found a three button switch housing with two buttons on the front and one on the back. I'll probably use the two front buttons for start and horn, and the back button for the engine kill switch. I won't have any buttons or switches on the clutch side.