Topic: Front Fork Lock Replacement - 1974 CB750 - Help Needed

[RRRToolSolutions]

I have looked through several sections of my Honda factory service manual, Honda's general service manual, but I cannot find where it explains the front fork lockset removal and installation. I just bought a NOS lockset from Western Hills and will be very happy about needing to carry around only 1 key.

Help/input appreciated.

Regards,
Gordon

[Bob Wessner]

If it hasn't changed from the earlier locks, if you have a key for the lock you want to remove, insert the key, turn it to the unlocked position and the lock mechanism should slide out after removing the screw.

[RRRToolSolutions]

Bob, thanks. I bet there is no key.....

 

[Jonesy]

If it is in the unlocked position, you can just pull it free with needlenose pliers after removing the screw and plastic cap.

[Weatherman]

Just did this myself. Pulls right out. Be careful not to loose the little spring.

[RRRToolSolutions]

Hey guys, it worked. I had a T1796 key which matched the number on the lock. It's odd though, I had to file down the sides of the key because it was too thick/wide to go into the steering lock. once I thinned it to .070 it went in. I guess the newer factory pre-cut keys are thicker. The lock turned to the left and pulled right out like you told me it would --

Thanks again.
Regards,
Gordon

[mcpuffett]

them locks are like rocking horse poo  , so don't lose it  ,   mick.