« previous next »
Pages: [1]   Go Down

Author Topic: Introduction  (Read 718 times)

0 Members and 1 Guest are viewing this topic.

Offline bs175dths

  • Full Member
  • *
  • Posts: 16
Introduction
« on: October 08, 2014, 07:41:26 AM »
I have owned this Honda since 1993.
It is a Special Construction originally tagged in 1977.
I was told the SOHC 750cc engine is from a 1975 CB but I am unable to verify that with the engine VIN.

My daily commute is a 1984 Honda Goldwing, a GL1200 Interstate with 144,000 miles.

Since 1984, I have owned over 35 motorcycles.
Most came to me not road worthy.  Three left as parts bikes and one left as I bought it, in a basket.

I like to tinker........ it relaxes me.

Thanks for the site and the opportunity to learn and share.

Logged

Offline goldarrow

  • one day, i'll be an
  • Old Timer
  • ******
  • Posts: 3,361
Introduction
« Reply #1 on: October 08, 2014, 09:22:22 AM »
Welcome. Would like to see the special construction
Logged
Life Is Full Of Challenges - And My Backyard Is Full Of SOHC4's

CB550 K0
CB750 K0, K2, K23 JDM, K45, K5
And the little ones z50r, xr50r, st90


750k5 http://forums.sohc4.net/index.php?topic=114817.0

Offline dusterdude

  • Really Old Timer ...
  • *******
  • Posts: 8,491
Re: Introduction
« Reply #2 on: October 08, 2014, 03:45:12 PM »
Welcome
Logged
mark
1972 k1 750
1949 fl panhead
1 1/2 gl1100 goldwings
1998 cbr600 f3

Offline WhyNot2

  • I'm finally an
  • Master
  • *****
  • Posts: 1,844
Re: Introduction
« Reply #3 on: October 10, 2014, 07:49:23 AM »
welcome, and let's see it........
Logged
If it ain't raining, I'm riding.....~~{iii}?~~prost

If it sounds like I know what I'm talking about, it's because I cut and pasted from someone else.

Offline bs175dths

  • Full Member
  • *
  • Posts: 16
Re: Introduction
« Reply #4 on: October 27, 2014, 09:15:56 PM »
I have replaced the original points, clutch and starter covers with finned, aluminum covers.  The post also shows a set of ten-spoke Invader rims (19" front and 15" rear) I am working on and a set of ones-to-ones I am also considering.  The frame is a Santee Soft-Tail, with a Santee oil/battery box, and Santee electrical and coil boxes.  Air filter is Henry-Abe as is the finned tappet covers.  The king-queen seat is made by Cheetah.  I found an incomplete set of Daniel-Boone forward controls on EBay and researched what I needed to make the set complete, then installed them.  The bike came with one Lucas Rectangular 8 with a smooth lens.  I found and added the fluted version to be used as low beam, the smooth is high beam.  I have a pair of Aris Triangular lights I will be installing.  The gas tank looks like a Mustang, but I haven't been able to confirm that.  Also in the wings is a Frisco styled Peanut gas tank.

Pun intended........ it has been a wild ride since I have owned it.

BTW, the engine is a 1975 F
« Last Edit: October 27, 2014, 09:49:03 PM by bs175dths »
Logged

Offline Stev-o

  • Ain't no
  • Really Old Timer ...
  • *******
  • Posts: 34,399
  • Central Texas
Re: Introduction
« Reply #5 on: October 27, 2014, 10:14:40 PM »
Welcome from Texas. Should look good with the drag pipes on
Logged
'74 "Big Bang" Honda 750K [836].....'76 Honda 550F.....K3 Park Racer!......and a Bomber!............plus plus plus.........
Pages: [1]   Go Up
« previous next »