Topic: Mikuni TMR32-D7 setup CB750 - Throttle Assembly KRS-001 on handle bar necessary?

[PeWe]

Better carbs on a CB750 K6:
There is a kit for the CB750, Mikuni TMR32-D7.
I got the information that a throttle adaptor is needed to fit. This is another throttle pipe with cables to be fitted on handlebar outside the existing . This will displace the right handle like +20mm. Throttle pipe in plastic will not cover the entire handle bar. Maybe 30-40mm outside when there is a stickout as it is today. If the bike will be dropped to the right side it will crack direct.

- Anyone that has installed TMR32 on a CB750?
- Not possible with std cables?

EDIT: Its called "Mikuni Push-Pull Throttle Assembly for Racing Carbs KRS-001"

My current VM29 throttle linkage look like a std setup as well as the TMR32's.
Below photos of the Mikuni throttle adapter and my current VM29.

[PeWe]

I'll answer later what needed to install them when I know, a few weeks from now.
Edit: CB750 stock cables and throttle grip work fine and has done so for 3.5 years now

[Retro Rocket]

http://www.allensperformance.co.uk/tmr32-d7.html

http://www.motorrad-fuchs.com/en/single,172,3,HONDA_CB_750_MIKUNI_TMR32.html