« previous next »
Pages: [1]   Go Down

Author Topic: Clear Tube Method Question  (Read 498 times)

0 Members and 1 Guest are viewing this topic.

Offline mrfish2

  • I might be a
  • Hot Shot
  • ***
  • Posts: 679
Clear Tube Method Question
« on: March 16, 2015, 02:30:55 PM »
Trying to check the float levels on my 76 550 (so the non-PD carbs) but I can't seem to find what the right size of clear tubing is. I tried 1/8 inch OD, but it was too small. Suggestions?
Logged
1976 CB550K            1979 XS1100
1980 CB650C - Sold

Quote from: crazypj on October 19, 2008, 09:14:45 PM
It's a little motor and likes having the tits revved off it.

Offline flybox1

  • My wife thinks I'm a
  • Really Old Timer ...
  • *******
  • Posts: 14,301
Re: Clear Tube Method Question
« Reply #1 on: March 16, 2015, 02:43:39 PM »
3/8 or 1/4" should work.
just taper it to fit in the drain screw hole.
Logged
'78 750K (F3 engine) PD42b's, Modified airbox w/K&N  filter, 40/110 jets, 1 needle shim, IMS@ 1 turn out. Kerker + Cone 18" QuietCore

Past Bikes
1974 550K0 (stock), 1973 CB350F (stock), 1983 Yamaha XS400K (POS)
77/78 cool 2 member #3
"Knowledge without mileage equals bullsh!t" - Henry Rollins

"This is my CB. There are many like it, but this one is mine…"

Offline tlbranth

  • Master
  • *****
  • Posts: 1,659
Re: Clear Tube Method Question
« Reply #2 on: March 16, 2015, 07:08:21 PM »
Quote from: flybox1 on March 16, 2015, 02:43:39 PM
3/8 or 1/4" should work.
just taper it to fit in the drain screw hole.

Yep
Logged
Don't own a Vanagon
Don't work at Boeing
Life is good

1970 CB750 K0
1975 GL1000
1999 GL1500
2002 VT750-CDA ACE - Momma's bike
Terry
Pages: [1]   Go Up
« previous next »