Tech Forums > SOHC/4 Bikes

Tapered Steering Bearings Thread

<< < (11/128) > >>

lassenc:
Is that the issue no matter which kind you go for?

crazypj:
As far as I know its the same for all taper roller bearings where loose ball bearings were standard.
Its not a big deal, I make some 5mm spacer washers for mine out of alloy tube, shines up nice. I'll take a pic and post it when I get home(if I can find out how!)
PJ

jtb:
I can't believe these K8 guys  would admit that they actually did something to IMPROVE their bike.  I thought (according to them) that a K8 couldn't be improved upon. :o ::) ;D

Quail "Owner of the comfortable k8":
I am sure the orig standard bearing felt as good when new I was just to cheap to get the oem part.  I may swith back now that you brought that up.  Damn I am back on this board after 2 months and someone is ragging my ride already.   HAHA 

eldar:
Dont sweat it quail. They are just in shock that someone tried to modify perfection found in a K8.

Navigation

[0] Message Index

[#] Next page

[*] Previous page