Topic: Piston and Rings

[benno88]

Hi all,

Need some more help this time its to find a set of standard Piston and Rings for a 750 K1. also I recently read an article on here about how to determine what colour bearing was installed from factory on the crank shaft, I know there is a number stamped on the fins of the block but just where it is.  if someone can dig that up for me would be most appreciated.

Cheers

[DaveBarbier]

I thought the stamp was on the back of the cases. Like where you route the carb overflow tubes.

[edwardmorris]

Hi all,

Need some more help this time its to find a set of standard Piston and Rings for a 750 K1. also I recently read an article on here about how to determine what colour bearing was installed from factory on the crank shaft, I know there is a number stamped on the fins of the block but just where it is.  if someone can dig that up for me would be most appreciated.

Cheers

DSS or yamiya for the pistons and rings. I found this image around here somewhere, can't dig up the thread but I had the image saved, hope it helps.

[flybox1]

Sizings will be etched (faint) on a lobe near the primary chain, and on the underside of the fins at the front of the upper case.
Bearing color is painted on an edge of the shell itself.