Topic: Main Jet 0 rings

[fodzilla]

Anyone know the size of the o-rings on the main jets?  There the push in jets on my carbs.

Frames a 73 k1 but the engine seems to be a k2 with 120 mains.  Not sure if these are original or previous owner fitted.

[HondaMan]

Anyone know the size of the o-rings on the main jets?  There the push in jets on my carbs.

Frames a 73 k1 but the engine seems to be a k2 with 120 mains.  Not sure if these are original or previous owner fitted.

Is this a CB500/550/400F/350F? Then they are 1x4mm, can also fit 1.1x3.9mm.

[fodzilla]

Thanks a lot!  Any of the forum users here from the UK and know a decent suppiler that isn't knocking them out for $8.00 with postage?

Must be able to get them in the UK of course!

[HondaMan]

Thanks a lot!  Any of the forum users here from the UK and know a decent suppiler that isn't knocking them out for $8.00 with postage?

Must be able to get them in the UK of course!

You might also try a Parker supplier, if there is one near you. They often have a crossover size reference to the SAE sizes. The 1mm is 0.40" in those section sizes.

[goldarrow]

I have extras of these o-rings, but I don't know if postage from USA to uk makes sense

[Tim2005]

What bike is this? I use 1.5 x 3.5mm ones in the 400f, they are a bit of a tight fit, but they do work ok, I do have some spare & am in UK...

[fodzilla]

What bike is this? I use 1.5 x 3.5mm ones in the 400f, they are a bit of a tight fit, but they do work ok, I do have some spare & am in UK...

Thanks for the responses!  I think I just found someone in the UK that can supply!  I'll let you know how I get one.

Where abouts in the UK are you Tim2005? I'm Manchester, always keen to meet a fellow fan!

SUPPLIER DETAILS http://www.exactrubber.co.uk