Author Topic: 74 CB 750 POPPING OUTTA 1ST  (Read 591 times)

0 Members and 1 Guest are viewing this topic.

Offline marty1969$

  • Full Member
  • *
  • Posts: 2
74 CB 750 POPPING OUTTA 1ST
« on: December 08, 2015, 11:42:16 AM »
are there dimensions on the inner and outter clutch and center clutch the discs go in, would this cause it to jump in and out of 1st, put new clutch discs and plates and even tore motor apart and replaced 1st gear and bushing 45T, EVERYTHING ELSE LOOKED GOOD INCLUDING SHIFTING FORKS AND DOGS

Offline goldarrow

  • one day, i'll be an
  • Old Timer
  • ******
  • Posts: 3,361
Re: 74 CB 750 POPPING OUTTA 1ST
« Reply #1 on: December 08, 2015, 11:57:07 AM »
Worn Shift drum?
Life Is Full Of Challenges - And My Backyard Is Full Of SOHC4's

CB550 K0
CB750 K0, K2, K23 JDM, K45, K5
And the little ones z50r, xr50r, st90


750k5 http://forums.sohc4.net/index.php?topic=114817.0

Offline 333

  • Time for change
  • Really Old Timer ...
  • *******
  • Posts: 7,558
  • Mail List Member #162 - Call me Stan
Re: 74 CB 750 POPPING OUTTA 1ST
« Reply #2 on: December 08, 2015, 08:18:11 PM »
I'd say bent shift forks.
Go metric, every inch of the way!

CB350F0  "Scrouching Tiger"
CT70K0    "Sneezing Poodle"

www.alexandriaseaport.org

Offline Gaucho

  • Enthusiast
  • **
  • Posts: 116
Re: 74 CB 750 POPPING OUTTA 1ST
« Reply #3 on: December 09, 2015, 10:28:37 AM »
Some reasons could be:
Worn shifter fork
Bent shifter fork
Worn clutch dogs
In any case, you won't be able to see any of this without engine teardown. :-(
Gaucho

Offline bear

  • Vale Bill McIntosh ......"illegitimi non carborundum"
  • Old Timer
  • ******
  • Posts: 2,575
  • Leeton in Australia
Re: 74 CB 750 POPPING OUTTA 1ST
« Reply #4 on: December 09, 2015, 03:30:04 PM »
Maybe we should check the easy stuff before you start pulling motors. ;)

If it where me I would start by checking to see if there is anything physically stopping the detent locating properly on the shift drum stopper.

If that checks out, try adding a little preload to the spring on the detent arm.

Cheers,
Brian

are there dimensions on the inner and outter clutch and center clutch the discs go in, would this cause it to jump in and out of 1st,

Short answer,  No.
« Last Edit: December 09, 2015, 03:36:10 PM by bear »
The older I get the faster I was.