Topic: Thread size rays

[Guido56]

Hello guys
Do any of you know what the thread pitch of the spokes and use to brush up on what male thread niplex?
Where to find it?
Sorry for my english
Thank you

[540nova]

Try Buchanan's for spoke info


Sent from my iPhone using Tapatalk

[Guido56]

Thanks but I need to know the thread pitch, I have to go over the hole niplex.

[strynboen]

is it metric  m 3.     3 milimeter auter diameter#0,5 in pitch...its just a guess i dont have valid data

[Guido56]

The radius and '3.5mm in diameter and the pitch looks 7mm (maybe 6.5) but does not exist in a table metric male 3,5x0,7 nor 3,5x0,65
Nor is it a step Whitworth
So maybe 'in inches or maybe some steps you use in the US
I am going through hard times'
 

[Bodi]

Jeez, I was hoping for a start wars spoiler about a new kind of death ray.

I can measure a spoke when I get home on Monday, if still needed. I presume they are a metric thread, there's no good reason for Honda to use inch sizing on spoke threads.

Just in case there's a difference... what bike model?

Note stock nipples may not work on alloy wheels - there is a variety of spoke hole sizes available on alloy wheels. Stock steel rims will match the originals. If you bought alloy rims on ebay or similar you may need special nipples (if the hole angles are even correct).

I made that mistake, and now have a pair of really nice 18" 36 hole shouldered alloy wheels that I can't use. Buchanans sold me a equally nice pair  and spoke sets - exactly correct for the front at least. Now I just have to get around to installing the rear one.

[Guido56]

The bike and 'the 750 Four K1 with circles and rays original DID
Thank you
 

[Guido56]

I was waiting for a response but I may have found the size of the fillets
You Can 'be 6-40 UNF?
I think so, someone measured?
The beam diameter and pitch and e'3,5mm '0,635