Topic: Removing Kick Starter roll pin "keeper"

[gdgreen56]

I've split the cases on my CB750K engine and am going through disassembly of the transmission and kick starter components in the upper case. There is a role pin that holds the kick starter shaft and gear in place. What is the best way to remove the pin without damaging it or the upper case?

[ekpent]

 If its the one I am thinking its hollow with a split along the side. Carefully squeeze it together and tap the tool with a hammer. I have used with caution dull wire cutters.

[edwardmorris]

Heat gun + dykes work well.

[gdgreen56]

Thanks very much for the replies! I'll give it a shot with the heat gun and dykes and let you know how it goes.

[Davez134]

Be prepared, it may likely be a PITA, especially if there is not much to grab. Remember to walk away if you feel like throwing something. . Mine was stuck so bad and down so far that I had to use a small drill bit to grab it and get it spinning inside first.

[70CB750]

I used vice grips on Dorothy, it came out eventually.

[Kevin D]

I used the diagonal cutters and levered it out pretty quick.

http://forums.sohc4.net/index.php/topic,38746.msg399632.html#msg399632