Topic: Webers for sale,less manifold cheap.

[754]

Ebay #152171363842 ........250 bux with wrong manifold.
Say DCOM..we use DCOE 40 series look like the same. Ask them what venturi size .
One diff I see the fuel inlet is not drilled down from the top , but rather the side.
Having touble expanding. Pic to read the series number..you want 40, not 45..

[754]

Do some reading before you buy, there is differences...and ask seller what it says on the series boss, and venturi size..

[scottly]

I thought the DCOM was a typo, but there really is such a thing! They use a diaphragm accelerator pump, instead of the piston in the DCOE. They also have vacuum ports for ignition advance. Never seen plastic stacks on a Weber before, either!

[754]

Apparently. The stacks do not interchange. With DCOE
 Venturi holder might be different,  a lot of stuff fits though..
 I did note he said or offer, so they are reasonable. If they are 40,s.... Bet they are not from Italy though.

[scottly]

It looked like I could almost make out 40 on one of them, and the seller does state that they are 40's, but I doubt he's an expert; the aux look like they are in backwards, as you can see the alignment pin. Very doubtful they are Italian, more likely Spanish.

[Tintop]

Very likely 40's, as they were used on early Alfa's.  The accel pump is same(?), or similar to the IDA.  Pretty sure they use the same chokes & and venturis as the DCOE's.

[754]

If you want to make your own manifold that flange cutoff is a good start.