« previous next »
Pages: [1]   Go Down

Author Topic: swingarm bushings again!  (Read 1503 times)

0 Members and 1 Guest are viewing this topic.

Offline cappy

  • Full Member
  • *
  • Posts: 48
swingarm bushings again!
« on: February 01, 2007, 09:59:37 AM »
Hello,

I am in the process of making a set of swingarm bushings for a 77’ CB550.  The dimensions I have are as follows: Flange dia. 1.25”, flange thickness ?, O.D. 1.047/1.050,
I.D. 22mm (nominal) fit based on measured pivot pin -.0005/-.0015”  bushing length inside of swingarm 2.00”  Can someone confirm these dimensions?  I have a detail drawing created in Autocad.  932 bearing bronze is the material.

Thanks in advance,
Greg.

Logged
GTR1400 KAWASAKI CONCOURS 08'
T500 TITAN 75'
YZ250 82'
CB550 77' BUILDING

Offline DrMark

  • Hot Shot
  • ***
  • Posts: 263
Re: swingarm bushings again!
« Reply #1 on: February 01, 2007, 03:45:22 PM »
Check with Hondaman....he makes them for some of the members here. He is a wonderful source of info.
« Last Edit: February 02, 2007, 09:48:05 AM by DrMark »
Logged
1978 CB550K
1983 CB650SC Nighthawk

Offline crazypj

  • I'm brill, me
  • Old Timer
  • ******
  • Posts: 4,468
  • first 100,000 miles. 1977 CB550F
Re: swingarm bushings again!
« Reply #2 on: February 02, 2007, 01:08:58 AM »
Probably a better idea to stick with metric measurements.
 I find they tend to be whole or half mm instead of odd ten thousandths of an inch
PJ
Logged
I fake being smart pretty good
'you can take my word for it or argue until you find out I'm right'
Pages: [1]   Go Up
« previous next »