« previous next »
Pages: [1]   Go Down

Author Topic: allen size  (Read 1156 times)

0 Members and 1 Guest are viewing this topic.

dwebber

  • Guest
allen size
« on: June 03, 2005, 05:15:28 PM »
I need the allen wrench size for the hex caliper bolts in a 1974 CB750K2
Logged

Offline Tim.

  • Master
  • *****
  • Posts: 1,945
  • www.DOTHETON.com
    • DO THE TON
Re: allen size
« Reply #1 on: June 03, 2005, 05:23:25 PM »
Ok, so two posts, and the same question twice.

Are you asking what size hex-head to use in a bolt on your bike?  These bikes didn't have hex-head bolts on them originally.  Probably 6mm if it's a larger bolt, but it could be 7 or 8mm as well.  Smaller hex-head bolts for the engine cases tend to all be 5mm.

Beyond that - seriously, get out your wrenches and figure it out.
Logged
Roule comme dans les années 70...   Roll as in the Seventies...

Offline Terry in Australia

  • Really Old Timer ...
  • *******
  • Posts: 33,363
  • So, what do ya wanna talk about today?
Re: allen size
« Reply #2 on: June 03, 2005, 05:30:29 PM »
Tintin, the "Doc" is asking what size allen head bolt "Hex Key" to use on a a CB750K2 caliper, to seperate the two halves. The OEM bolts are of the "Allen head" (internal hex) variety. The answer is 8mm. Cheers, Terry. 8)
Logged
I was feeling sorry for myself because I couldn't afford new bike boots, until I met a man with no legs.

So I said, "Hey mate, you haven't got any bike boots you don't need, do you?"

"Crazy is a very misunderstood term, it's a fine line that some of us can lean over and still keep our balance" (thanks RB550Four)
Pages: [1]   Go Up
« previous next »