« previous next »
Pages: [1]   Go Down

Author Topic: CB750 K7  (Read 1336 times)

0 Members and 1 Guest are viewing this topic.

Sapphireminer

  • Guest
CB750 K7
« on: June 23, 2018, 12:46:36 AM »
Hi everyone here is the photos of my K7 I just purchased with intention of rebuilding over the next year or so. Thank you for viewing. Dave
Logged

Offline KB02

  • Take it easy there, Sonny, I'm an
  • Old Timer
  • ******
  • Posts: 3,760
Re: CB750 K7
« Reply #1 on: June 23, 2018, 05:56:33 AM »
Looks like an interesting project. Are you going to keep that knobby rear tire?  ;D

What direction are you going? Chopper, Cafe, Restore? Looks like a solid base for any choice.
Logged
1978 CB750K Project
2000 Ducati ST2
...and a pedal bike

Join the AMA today!!

My project thread Part I: K8 Project "Parts Bike"
My project thread Part II: Finishing (yeah, right) touches on Project "Parts Bike"

Sapphireminer

  • Guest
Re: CB750 K7
« Reply #2 on: June 23, 2018, 08:48:56 PM »
Hi KB02 I will be going back to Stock streat bike. I would like to go to another chopper like I had when I was 20 I loved riding that bike  but now nearly 60 not so sure will see how this one goes then maybe the next one. Have a nice day.
Dave
Logged

Offline dunc

  • Full Member
  • *
  • Posts: 60
Re: CB750 K7
« Reply #3 on: June 28, 2018, 12:19:37 AM »
Nice place to start. Looking forward to seeing it come along!
Logged
it's amateur hour somewhere.

Sapphireminer

  • Guest
Re: CB750 K7
« Reply #4 on: July 24, 2018, 11:45:24 PM »
Have the old girl stripped down (no not the wife) will be getting a water pressure washer and some paint stripper next week and will start on the frame paint work it will be a home job worst that can happen is I stuff it up and have to start again not a lot lost and a new experience gained. Have the top end of motor apart all looks quite good will take it to a engine rebuilder to check barrel and piston wear as I don't have the equipment to see if we need a rebore. Will see how the paint comes out in a couple of weeks will post a photo of the frame when painted here is one of her now all bare as.
Thanks for reading Dave
« Last Edit: July 24, 2018, 11:46:57 PM by Sapphireminer »
Logged

Sapphireminer

  • Guest
Re: CB750 K7
« Reply #5 on: September 04, 2018, 07:05:39 PM »
Finally got a small job done on the bike repaired the cracks in the seat pan and painted then replaced the broken tabs on the pan with the furniture spikes  to fix the new cover used the old foam as it is in reasonable condition over all didn't come up to bad. Currently started to do seals in forks but run into more problems with internal parts missing thanks to POs.
Dave
Logged
Pages: [1]   Go Up
« previous next »