Topic: *1' Honda cb900c broken Carburetor float pin Mount

[Boots_81_cb900c]

So the other day i was trying to remove the Float pin from my #4 carb on my 81' Honda cb900c, when i began to tap the pin out (after i sprayed PB blaster on it and let it sit) the Pin mount broke in half. What is the best way to go about fixing this issue? or where could i send it to get it micro welded back on? and lastly, does anyone have an extra #4 carb laying around that they would let me take off there hands?

[Boots_81_cb900c]

Here is a Pic of the mount

[ekpent]

 This is our resident micro welder on the forum ---  http://forums.sohc4.net/index.php/topic,18649.0.html

[Don R]

 Mine broke at the pin hole. I used a brass bullet case over the pin with some JB weld. Then redrilled the hole out and last I knew it was working fine.

[MoMo]

I'll vouch for Jim French's work.  Top notch and reasonable...Larry

[Boots_81_cb900c]

I emailed Jim and spoke with him on the phone!! Sending the carb to him at the beginning of next week.

 I appreciate the Help gentlemen.

Ill Post the finished product when i get it back from him.

[Don R]

 Good choice.