Author Topic: CB350K3 - yeah, I know...  (Read 644 times)

0 Members and 1 Guest are viewing this topic.

Offline Knoxes

  • Full Member
  • *
  • Posts: 3
CB350K3 - yeah, I know...
« on: September 09, 2019, 06:39:34 AM »
I'm just here looking for a pic, but the site won't let me search.  I'm guessing that's because I don't have enough posts?

In the last post on this thread:

http://forums.sohc4.net/index.php?topic=162263.0

tacc13 mentions that he posted a photo of some Tomaselli clip-ons that were drilled out for internal wiring.   I'm trying to figure out the same thing and it would be awesome if I could see that pic.


Offline jgger

  • Master
  • *****
  • Posts: 2,345
Re: CB350K3 - yeah, I know...
« Reply #1 on: September 09, 2019, 06:57:16 AM »

Posts: 77 

Re: CB550 Project Start

« Reply #52 on: April 25, 2018, 01:12:37 am »

Quote

Bit the bullet and decided to run the bar wiring internally. I got some advice from the blokes at Revival Cycles as there is a small amount of modification required. I drilled a 4mm hole at the end of the bar and had to enlarge the internal diameter slightly. I used two cheap ebay tools for about $5 each. I need to make the exit hole a bit neater and larger so I can run the braided covering.


 Bars1.jpg (123.63 kB, 2048x1152 - viewed 20 times.)

 Bars2.jpg (162.39 kB, 2048x1152 - viewed 19 times.)

 Bars3.jpg (301.24 kB, 2048x1152 - viewed 23 times.)

 Bars4.jpg (53.9 kB, 450x800 - viewed 22 times.)

Is that what you were after?
"The SOHC4 uses a computer located about 2-3 ft above the seat.  Those sometimes need additional programming." -stolen from  Two Tired

The difference between an ass kisser and brown noser is merely depth perception.  Stolen from RAFster122s

Offline Knoxes

  • Full Member
  • *
  • Posts: 3
Re: CB350K3 - yeah, I know...
« Reply #2 on: September 09, 2019, 07:37:24 AM »
Ha!  Either I've screwed up the settings or this site is pic blocking me!

Thanks for the effort, but all I can see is:

Bars1.jpg

Bars2.jpg

etc.

This is really weird.  If I go into a thread, I can definitely see pics. 

Offline Knoxes

  • Full Member
  • *
  • Posts: 3
Re: CB350K3 - yeah, I know...
« Reply #3 on: September 09, 2019, 07:49:48 AM »
Thanks for the time and date stamp, though.  I had to scroll and {CTRL-F}, but I eventually found the thread. 

Offline jgger

  • Master
  • *****
  • Posts: 2,345
Re: CB350K3 - yeah, I know...
« Reply #4 on: September 09, 2019, 12:29:14 PM »
It's not the site.........its my impeccable computer skills!🙈🙉🙊
"The SOHC4 uses a computer located about 2-3 ft above the seat.  Those sometimes need additional programming." -stolen from  Two Tired

The difference between an ass kisser and brown noser is merely depth perception.  Stolen from RAFster122s