Topic: cb750 k2 alternator wiring harness routing?

[CaptFatCat]

cb750 k2 alternator wiring harness routing?

I cannot figure out the proper way to route the wiring harness from the alternator with the 3 yellow bullet connectors, oil light and neutral switch thru the counter sprocket cover and shift cover. are the bullet connectors exposed under the sprocket cover?
will someone post a pic for me?

Thanks

[69cb750]

Wires route through crankcase slot on left then turn in between case and lip on sprocket cover.

[PeWe]

Pics from my K2 build.
3 yellow alternator wires + 2 wires for field coil sitting in the cover meet the upper harness with neutral switch wire to rectifier inside the shift cover/sprocket cover. You'll see when alternator cover goes on. Do not forget the rubber these wires goes thru on alternator cover. There is a bracket there too.
Oil pressure sensor wire with starter motor cable.

[CaptFatCat]

Thanks PeWe.

The pics are great.
I was lost on where to tuck the bullet connectors under the sprocket cover.
It didnt seem right having them located where the chain can sling grease on it. I see they can be tucked away and strapped with the keeper on the case.

[CaptFatCat]

P.S.
That is a Fine looking motor PeWe!

[PeWe]

Thanks. You can see it here
https://r.tapatalk.com/shareLink/topic?url=http%3A%2F%2Fforums%2Esohc4%2Enet%2Findex%2Ephp%3Ftopic%3D168243%2E0&share_tid=168243&share_fid=13548&share_type=t&link_source=app