Author Topic: Oh dear ... (Read 43524 times)

69cb750 · « **Reply #25 on:** April 22, 2020, 12:19:59 PM »

Quote

Later 392 K7 pistons to get some extra CR?

I am using the original 300 pistons, the 394 pistons are higher compression.

69cb750 · « **Reply #26 on:** April 22, 2020, 12:21:24 PM »

69cb750 · « **Reply #27 on:** April 22, 2020, 12:22:22 PM »

69cb750 · « **Reply #28 on:** April 30, 2020, 10:52:32 AM »

754 · « **Reply #29 on:** April 30, 2020, 02:00:51 PM »

If that distance collar is not yet back in the wheel, can you measure length with calipers ? Please.
Do you still need a centerstand ? Do you have the pivot, Crescent or spring ?

69cb750 · « **Reply #30 on:** April 30, 2020, 05:03:46 PM »

Quote

If that distance collar is not yet back in the wheel, can you measure length with calipers ? Please.
Do you still need a centerstand ? Do you have the pivot, Crescent or spring ?

I installed new wheel bearings on Monday, bearings are .511" wide so collar = od - 1.022"
I have center stand, thanks

69cb750 · « **Reply #31 on:** April 30, 2020, 05:04:24 PM »

HondaMan · « **Reply #32 on:** April 30, 2020, 05:10:24 PM »

Quote from: 69cb750 on April 30, 2020, 10:52:32 AM

You have an SOHC5?

TjTalan · « **Reply #33 on:** April 30, 2020, 08:22:16 PM »

Subscribed, I think I now need a Tracy in my life!

Sent from my iPad using Tapatalk

69cb750 · « **Reply #34 on:** May 01, 2020, 01:06:40 PM »

Quote

You have an SOHC5?

Allen Millyard is my cousin.

69cb750 · « **Reply #35 on:** May 01, 2020, 01:07:52 PM »

69cb750 · « **Reply #36 on:** May 01, 2020, 01:08:34 PM »

Stev-o · « **Reply #37 on:** May 01, 2020, 01:11:49 PM »

Quote from: 69cb750 on May 01, 2020, 01:06:40 PM

Quote
You have an SOHC5?

Allen Millyard is my cousin.

The "local madman"?!

https://www.rideapart.com/articles/303905/allen-millyard-custom-kawasaki-v12/

754 · « **Reply #38 on:** May 01, 2020, 02:03:30 PM »

I meant the length of the Inner spacer aka distance collar, in case any one is stuck and needs to make one.
Bearings are easy, you can figure out the width by their number. . Most times.