« previous next »
Pages: [1]   Go Down

Author Topic: cb750 camshaft end bolt torque?  (Read 344 times)

0 Members and 1 Guest are viewing this topic.

Offline macvit7906

  • Enthusiast
  • **
  • Posts: 221
cb750 camshaft end bolt torque?
« on: March 14, 2020, 07:20:03 PM »
Installing a new webcam.

Is there a special torque spec for the camshaft end bolt that holds the washer on the end?
Number 7 here: http://www.hondachopper.com/engine/fiche_pages/F0/F0-Camshaft_Towers.pdf

Or just follow the 8mm torque spec of 14.5 ft-lbs? use some red loctite?

Logged

Offline MRieck

  • Really Old Timer ...
  • *******
  • Posts: 10,582
  • Big ideas....
Re: cb750 camshaft end bolt torque?
« Reply #1 on: March 15, 2020, 08:48:50 AM »
 Be careful holding the cam....don't snap a flange off (I have seen it done) ::) Blue loctite is fine Matt....just clean the bolt and hole with brake cleaner before assembly.
Logged
Owner of the "Million Dollar CB"

Offline macvit7906

  • Enthusiast
  • **
  • Posts: 221
Re: cb750 camshaft end bolt torque?
« Reply #2 on: March 15, 2020, 09:08:24 AM »
Quote from: MRieck on March 15, 2020, 08:48:50 AM
Be careful holding the cam....don't snap a flange off (I have seen it done) ::) Blue loctite is fine Matt....just clean the bolt and hole with brake cleaner before assembly.

Thanks Mike! Will be careful and go to 14 ft-lbs with blue loctite
Logged
Pages: [1]   Go Up
« previous next »