Topic: substitute part for CB350F carburetor

[mrenfro]

wondering if anyone has found a suitable substitue part for the little pins that are part of the adjusters for the carburetors.  These pins (16 total for the complete carb set) have a dimple on the pin head that acts as a socket for the ball that is part of the linkage.

'm working on a chromebook right now so can't figure out how to post a pic.

any help is appreciated.

[Bodi]

No. Pretty small for 3D printing. Maybe you could get a rod of something - are they graphite? - and make some?
Every Keihin rack with that lever slide lift system I've worked on uses the exact same parts. Some folks on here have a lot of carb racks and sell parts, you can try the wanted forum?

[mrenfro]

ok thanks.  I don't think they are graphite as they are attracted by a magnet.  I may try the wanted section like you mentioned.