Topic: Wrong clutch lever ?

[denward17]

Do I have the wrong clutch lever ? 

Acquired the bike like this, I suspect it is the wrong lever, but don't know for sure.

'76 CB550K, see pic below.  The lever does not close all the way, it hits the stop where the pen is pointing.

Any ideas?

[bryanj]

Yup. From a different model

[jlh3rd]

That lever doesn’t fit that holder.
I’m assuming the holder (winker switch) is the correct one for that 550.
I say that because you bought a used bike and you never know what a PO had done.
The levers are available.

[denward17]

Thanks Guys....

[BenelliSEI]

Den…… I have a bag full of good used. Let me have a look. John D.

[denward17]

Den…… I have a bag full of good used. Let me have a look. John D.

Thanks John, but no need.  I need to buy some parts from vintage so will just throw that in, less than $5.

[BenelliSEI]

Den…… I have a bag full of good used. Let me have a look. John D.

Thanks John, but no need.  I need to buy some parts from vintage so will just throw that in, less than $5.

Sure you don’t want a match? I’ll phot if I have one……

[denward17]

Den…… I have a bag full of good used. Let me have a look. John D.

Thanks John, but no need.  I need to buy some parts from vintage so will just throw that in, less than $5.

Sure you don’t want a match? I’ll phot if I have one……

Would prefer a match, let me know, Thanks.

[BenelliSEI]

I have one. The rubber end is torn. Pull it off and polish both?

[denward17]

I'll take it!

This is for a 550 correct?

Sending PM...

[BenelliSEI]

I have a bucket full and this is the only one I have that looks right. My buddy Gary and I have had four 550’s, so probably.