« previous next »
Pages: [1]   Go Down

Author Topic: ngk connectors HELP  (Read 942 times)

0 Members and 1 Guest are viewing this topic.

Offline neil young

  • striving to be an
  • Expert
  • ****
  • Posts: 931
  • A penny saved..is obviously a government oversight
ngk connectors HELP
« on: June 08, 2007, 05:57:17 PM »
i bought 4  7mm ngk connectors,new plugs which i have not put in yet,new 7mm wire and new plug caps (ngk).i cut off the old wire on my cb 550  4" to 5" away from the coil as directed,then installed # 4 first.then i thought i would try to start the bike to make sure everything was alright befor cutting # 1,# 2 and #3.well sure enough # 4 is not fireing.so i pulled apart the new wire to the connector and everything seems alright so i put it back together and still no # 4 .....any ideas as to what the problem might be?i dont want to cut 1  2  and 3 before i figure this out.any help on this would be great :-\
Logged
1972 CB500 k1
1974 CB550
1977 cb 550
82 suzuki GS 750tz.......16  valves  baby
2008 Triumph Scrambler

Offline Killer Canary

  • Master
  • *****
  • Posts: 1,805
  • Typical Bran Muffin
Re: ngk connectors HELP
« Reply #1 on: June 08, 2007, 10:27:00 PM »
Measure continuity using an ohmeter. Put one lead in the #1 plug cap terminal and the other lead in the #4 plug cap terminal. If they're resistor caps, the reading should be 33,000 ohms.
Logged
If it's worth doing at all it's worth over-doing.
Honda MT250, CB400F, CB450K, CB550, GL500, CBR929
Kawi GPz900, H1
Pages: [1]   Go Up
« previous next »