« previous next »
Pages: [1]   Go Down

Author Topic: Spring compressor  (Read 1104 times)

0 Members and 1 Guest are viewing this topic.

Offline mmtsquid

  • Hot Shot
  • ***
  • Posts: 393
Spring compressor
« on: July 18, 2007, 09:57:07 AM »
What kind of spring compressor should I buy to deal with my shocks?  I looked on e-bay, and there are 206 different ones on there.......HELP!!!
Logged
77 CB550K4

Offline Tim2005

  • Expert
  • ****
  • Posts: 1,391
Re: Spring compressor
« Reply #1 on: July 18, 2007, 11:13:46 AM »
Logged

Offline puppytrax

  • Expert
  • ****
  • Posts: 1,059
Re: Spring compressor
« Reply #2 on: July 18, 2007, 02:48:06 PM »
Well, I'm a cheap SOB...and I have a Sears bench vise bolted to my bench...

So I found an old piece of 3" angle iron, cut a 5/8" slot in the middle of it, and bolted it *behind* my vise...

So now I open the vise all the way, put a long bolt in the bottom of the shock and butt it against the end of the movable jaw and fit the angle iron between two coils and crank the vise in...and remove the shock clips and take the spring off...

I have done a bit of "customizing" to my angle iron...cleaned it up, bent the sides to match the angle of the coils, etc...

Cheap, effective, and simple...   ;D
Logged
...stock 1972 CB500 '500 Four' undergoing re-assembly...
...Stock 1972 CL450 'Scrambler' also being re-assembled...

Offline kghost

  • Really Old Timer ...
  • *******
  • Posts: 6,855
  • www.facebook.com/RetroMecanicaAustralia
Re: Spring compressor
« Reply #3 on: July 18, 2007, 02:50:59 PM »
I'm even cheaper than you......


I use 6 zip ties tightened incrementally  ;D
Logged
Stranger in a strange land
Pages: [1]   Go Up
« previous next »