Tews, look at the last pic..
Where shall I start..
The area around the points has been replaced with bigger tubing. Then the 2 front mounts are not in line.
Visible in the pic, I will get closeups.
Then the whole kickstand side lower tune is pushed up, you can see a big wrinkle above side stand and another by front lower mount, the kickstand bracket is angled out and up about 10 degrees..
Sounds bad, there is more.
The rear frame by fender mounts is pushed down about1/ to 1/2 inch, taillight was drooping.
And I thought that was bad, but..
The shock mounts also are angled wrong..
And then , unbelievably, after we pulled motor I realized cross bar that supports center stand is also bowed up..
Other than that, not too bad..
And the engine, surprisingly faired pretty good..
One main bolt boss by the points is welded, pretty good job..
And the fukstik welded up the place a drain plug should be on the oilpan.. yes really..
First bike I had to drill a hole in the pan to drain the oil..
