« previous next »
Pages: [1]   Go Down

Author Topic: Doubled engine mounts  (Read 601 times)

0 Members and 1 Guest are viewing this topic.

WHALEMAN

  • Guest
Doubled engine mounts
« on: May 22, 2008, 05:25:22 PM »
One topic I have never seen and could not find in the search is if anyone has any experience in running double engine mounts braces. These are the two triangle steel pieces on the right side that connect the engine to the frame. I read somewhere that the CR's always did this.
Logged

Offline cafe750

  • Hot Shot
  • ***
  • Posts: 583
  • If you can't fix it with a hammer, it's electrical
Re: Doubled engine mounts
« Reply #1 on: May 22, 2008, 07:41:10 PM »
I do believe Hondaman talks about this, either in the "Thoughts of Hondaman" thread in the FAQ's, or search Handling...you'll find stuff on it....Hope this helps!
Logged
"It's an old motorcycle, the wind is supposed to blow your head around, it's supposed to leak oil, the brakes should suck, and every now and then, it should scare you so bad you piss your pants."



Roy, Washington

Offline MRieck

  • Really Old Timer ...
  • *******
  • Posts: 10,596
  • Big ideas....
Re: Doubled engine mounts
« Reply #2 on: May 22, 2008, 08:13:52 PM »
 I made one 3 times as thick. Kosman offered kits for years for the Z and K engines
Logged
Owner of the "Million Dollar CB"
Pages: [1]   Go Up
« previous next »