Author Topic: Rotor surface finishing (Read 6492 times)

rbmgf7 · « **on:** June 22, 2008, 01:01:05 PM »

mystic_1 · « **Reply #1 on:** June 22, 2008, 03:43:32 PM »

Awesome!

mystic_1

Steve F · « **Reply #2 on:** June 23, 2008, 02:15:51 AM »

How did you do the other side? Any luck?

Pawsoff · « **Reply #3 on:** June 23, 2008, 03:18:24 AM »

well you gotta love that, nice method

francisew · « **Reply #4 on:** June 27, 2008, 10:25:22 AM »

Was that a dremel?

Looks good, did it brake well after?

rbmgf7 · « **Reply #5 on:** June 27, 2008, 12:18:26 PM »

How did you do the other side? Any luck?

just flip it over and repeat

Was that a dremel?

Looks good, did it brake well after?

it was a die grinder with a 3M sanding abrasive disc.

don't know yet, still putting the bike back together

750goes · « **Reply #6 on:** June 27, 2008, 03:32:33 PM »

excellent ingenuity - does it finish off the disc evenly or is it a very light skimming of the surface ??

rbmgf7 · « **Reply #7 on:** June 27, 2008, 07:09:54 PM »

it's just skimming the surface. perhaps if i use a 3" disc i could get a better, more even surface then with a 2"

thomellis · « **Reply #8 on:** December 07, 2011, 02:30:22 PM »

I realize this is pretty old, but it looks like the link is dead?

rbmgf7 · « **Reply #9 on:** December 16, 2011, 06:36:30 AM »

I realize this is pretty old, but it looks like the link is dead?

SOHC/4 Owners Club Forums