« previous next »
Pages: [1]   Go Down

Author Topic: o-rings too big  (Read 863 times)

0 Members and 1 Guest are viewing this topic.

Gittfiddler

  • Guest
o-rings too big
« on: July 28, 2008, 08:48:39 AM »
hey all, got a gasket set for my 72' cb350 twin from sirius and it had 2 larger diameter o-rings, 1 for the hole in the clutch cover around where the oil filter is and one to go around the oil filter cover.  tried to install them but they were way too big.  am i missing something here, is there a way shrink them?
Logged

Offline tbpmusic

  • Expert
  • ****
  • Posts: 791
Re: o-rings too big
« Reply #1 on: July 28, 2008, 11:40:56 AM »
Are the two o-rings the same size??
If so, it may be possible that they're for the cylinder/crankcase "joint".

bill
Logged
"If you can't fix it with a hammer, then it's an electrical problem"

Bill Lane
 '71 CB450 Mutant/ '75 CB200/ '81 CM200/ '71 C70M

Gittfiddler

  • Guest
Re: o-rings too big
« Reply #2 on: July 28, 2008, 04:17:10 PM »
I am an idiot, they are for the bottom of the jugs.  sorry
Logged
Pages: [1]   Go Up
« previous next »