Here is a fairly complete tech sheet on the bike as it sits now:
rear frame rails chopped behind shock mounts
all useless frame tabs cut and ground off
DupliColor rattle can paint EVERYWHERE except for
truck bed liner on tank, headlight bucket and custom seat
full top end tear down and rebuild, all genuine Honda gaskets etc
ceramic coated then wrapped Mac (?) header pipes
custom taper/flange for muffler in stainless, home made muffler hanger clamp
Two Brothers carbon exhaust from CBR600RR
2 sets of Keihin PD41 carbs rebuilt, cleaned etc with 120 and 122.5 mains
all engine bolts stainless steel hex head
all critical bolts either grade 8 or 10
Marshall oil pressure gauge tapped into oil journal
K4 Tach with custom single mount
K4 (?) idiot light cluster (with all LED lamps)
SunStar front (15 and 16) and back (38 and 41) sprockets, 630 RK O ring chain
custom spin on oil filter set up and Lockhart cooler (Terry from Oz) with K&N filter
Emgo (?) pod air filters, stainless intake manifold clamps
Progressive Suspension gas charged shocks
Progressive Suspension fork springs and RaceTech gold cartridge valve emulators and GOKI air valve top caps
all new Honda seals,dust caps, etc and front fork hardware
All Balls tapered roller steering head bearings
EBC brake pads front and rear, rebuilt front caliper and master cylinder
Stripped stock footpegs with covers made from LED flashlights
fork brace off stock fender with Carpy fender
Kuryakyn mirrors, headlight brackets
Parts Unlimited dogleg "magura style" shorty levers
home made curved license plate holder with LED lights
home made alloy electrics side panel with key cylinder installed
home made 6061 brake anchor arm
3 Ohm Dyna coils, Accel 8.8 wires, platinum Irridium resistor plugs
Hondaman Ignition box and resistor pack
Metzeler ME550 140/80 VB18 rear, Cheng Shin Barracuda 100/90 19 front tire
Superbike bars with weighted bar ends
handlebar switches from earlier K model
Superbike grips
GreenJeans badges
new Honda and Motion Pro cables
new solid state regulator/rectifier, starter solenoid, bladed fuse box
relayed Sylvania SilverStar H6024 headlight with on/off switch on top of headlight bucket
most bullet and multi pin connectors have been replaced, switches refurbished
clear lens w/ amber LED front signals
Custom Dynamics flexible LED tail/brake/signal light
secondary LED signals in rear frame rails
LED friendly flasher relay
BackOff! XP brake light modulator
Cateye bicycle computer for speedo
Neodymium magnets along frame bottom to trigger turn lights
red fuel lines
customized finned side covers
91 octane w/ a little SeaFoam
BelRay fork oil
10/30 or 20/50 Honda HP4 oil
N12 15 amp hour AGM battery
2 hidden power cut off switches because key is broke off in cylinder and I turn it with either a nickle or M10 washer Wink
$50 cafe fairing that comes and goes at whim
In the works:
Tarrozzi fork brace
re-lace wheels w/ Buchannon SS spokes (2 broken rear spokes currently)
braided SS brake line
EBC rotor
horn(s) with relay
K&N oval pod filters
custom hump style seat pad